CleaningTheShaver - Panasonic ES-LT33 Mode D'emploi

►Notes

• If you press the power switch for more than 2 seconds, the sonic
vibration cleaning mode is activated. (See this page.)
You cannot shave in this mode.
• Do not place your fingers on the power switch while using the
shaver. This may cause the shaver to turn off or enter the sonic
vibration cleaning mode. Place your thumb on the thumb rest
while using the shaver.
• We recommend using the shaver in an ambient temperature
range of 5 – 35 °C (41 – 95 °F). If used outside this range, the
appliance may stop operating.
Readinglampswhenusing
While using
Approximate amount of battery charge is
displayed as 20 – 100.
• It will turn off approximately 5 seconds after operating the switch.
When the battery capacity is low
"20" blinks when operating the shaver.
• You can shave 2 to 3 times after "20" appears. (This will differ
depending on usage.)
• A full charge will supply enough power for approx. 14 shaves of 3
minutes each. (This will differ depending on usage.)

Cleaningtheshaver

1. Disconnect the cord from the shaver.
2. Apply some hand soap and some
water to the system outer foil.
3. Rotate the lock ring to unlock the
power switch.
4. Press the power switch for more than 2
seconds to activate the sonic vibration
cleaning mode.
• The battery capacity indicator blinks
in order.
• After about 20 seconds, it will be
automatically turned off, or you can
turn it off by pressing the power switch.
5. Remove the outer foil section and
press the power switch for more than 2
seconds to activate the sonic vibration
cleaning mode and clean it with
running water.
6. Wipe off any drops of water with a dry
cloth.
7. Dry the outer foil section and the
shaver completely.
8. Attach the outer foil section to the
shaver.
4
5
7
11