Panasonic ES‑LV9Q Mode D'emploi page 12

Charging without the self-cleaning recharger
• Turn the shaver off.
• Wipe off any water droplets on the appliance socket.
1
Insert the appliance plug into
the shaver�
2
Plug the adaptor into a
household outlet�
3
Disconnect the adaptor after
charging is completed�
Note
You cannot operate the shaver while charging.
Preparing the cleaning liquid
Cleaning can start right after the usage by preparing in advance.
(See page 15.)
• Remove the AC adaptor from the self‑cleaning recharger.
1
Press the cleaning
liquid unit removal
button (1) and
remove the cleaning
liquid unit (2) on a
hard, fl at surface.
• When the self‑cleaning recharger is lifted, or on the soft
surface such as carpets, the lock release lever will not fi t in
the recharger properly. In that case, the cleaning liquid unit
cannot be removed.
12
ES-LV9Q_US.indb 12
2
1


2
Pour tap water (1) and
detergent (2) into the
cleaning liquid unit�
• Be careful not to let the
water rise above the
maximum water line (a).
• Pour the entire packet of
detergent.
3
Slowly insert the
cleaning liquid unit into
the self-cleaning
recharger until it clicks�
Notes
• To replace the cleaning liquid, see page 18.
• Only use self‑cleaning recharger detergent for Panasonic
shavers.
Not doing so may cause malfunction or failure.
• Do not tilt the self‑cleaning recharger.
Doing so may cause spill or the number of days that cleaning
liquid can be used reduce.
• You can use the cleaning liquid for approximately 30 days if used
once per day.
(This will differ depending on beard thickness and the ambient
temperature.)
 

2018/03/02 15:51:14