Napoleon Altitude X AX36NTE Manuel D'installation page 43

9.8 clearances around appliance (TV and valuable objects)
Flush installation without
mantel
TV bracket
Enclosure
Top of
finishing
flange
Appliance (fireplace
opening)
Partially recessed installation with mantel
6" min.
TV bracket
2.5" min.*
2" min.
3" max. recommended)
A or B
Enclosure
Top of finishing flange
(fireplace opening)
Appliance
note:
• Electronic appliance temperatures must be validated at the time of installation as air fl ow
characteristics within the room can vary and maximum acceptable operating temperatures can vary from
appliance to appliance. Electronic appliances cannot be used where the electronic appliance temperature
exceeds the manufacturer's maximum allowable operating temperatures (see electronic appliance
manufacturer's specifi cations). Operating a television above the manufacturer's maximum allowable
operating temperature will result in premature failure.
• Mantel height and depth must conform to mantel clearance requirements specifi ed in this manual, see
"minimum clearance to combustible mantel" section in installation manual.
• Electronic appliance temperatures may be further reduced by increasing the horizontal distance between
the front of the electronic appliance and the front edge of the mantel or by increasing dimension "A" or "B".
However, increasing the gap between the top of the mantel and the bottom of the electronic appliance
beyond the maximum recommended fi gure, typically results in higher temperatures. Minimum clearance
between the mantel and bottom of the electronic appliance should be maintained to allow air circulation
below and behind the electronic appliance.
Flush installation with
mantel
6" min.
TV bracket
2.5" min.*
2" min.
(3" max. recommended)
A or B
Enclosure Enclosure
Top of finishing flange
(fireplace opening)
Appliance
*
series with the minimum enclosure dimensions and
the maximum recess permissible. Temperatures
suitable for operating typical televisions, whilst
operating the fi replace, were obtained with a
minimum of a 7" mantle protrusion from front
surface of the TV. This data is provided in good
faith and is not a guarantee for every application
and television. Care and consideration should
be taken when planning these installations to
See "minimum clearance to
ensure the temperatures around the TV meet
A
mantle" section (installation
manual).
all manufacturer's recommended operating
Mantle clearances reduced
temperatures. Increasing the height of the
B
from opening with the use of the
Altitude™ X heat management
mantel and/or TV above the fi replace opening,
system.
the protrusion of mantel and the volume of the
enclosure all have the effect of reducing the
temperature above the fi replace. It is always
recommended to use the optional heat
management kit when considering mounting a
television above the fi replace.
Recessed installation with
protrusion
6" min.
2" min.
(3" max. recommended)
Enclosure
Appliance
The volume of air must be added to the enclosure
to accomodate the recessed area.
TV applications were tested with the Altitude™ X
fi nishing
TV bracket
2.5" min.*
Top of finishing flange
(fireplace opening)
43
W415-1935 / C / 01.13.20
EN