HC Cargo 161122 Manuel Du Propriétaire page 7

HOW TO REPLACE BATTERY USING THE POWER SUPPLY FEATURE
1. Connect the charger/power supply to the wall socket. The LCD monitor shows the
defaults of battery types/ output modes.
2. Press the Mode/Type button to select the Power supply program. Then it will count down
automatically for 5 seconds.
3. Connect 161123 & Car's ECU to an active accessory outlet or clamping directly to the
battery terminal.
4. The error (ER5) icon will illuminate if the battery voltage is less than 8V. Please refer
to the troubleshooting guide to solve the problem.
5. After making sure 161123 & Car's ECU is actively connected, disconnect the battery
terminal from the old battery and remove the old battery. The 161123 will supply the
power to maintain car's ECU memory during this process. Note: 1. Please don't let the
battery terminal (+) (-) touch any metal part of the car, or it could disrupt or damage
the circuits in the vehicle. 2. Please do not let the battery terminal (+) (-) touch
together, or it could disrupt or damage the circuits in the vehicle.
6. Install a new (good) battery. After connecting the new battery and connecting the
battery terminals, you can stop the power supply function by disconnecting the AC Plug
from the wall socket.
Note: 1. Please don't let the battery terminal (+) (-) touch any metal part of the car, or
it could disrupt or damage the circuits in the vehicle. 2. Please do not let the battery
terminal (+) (-) touch together, or it could disrupt or damage the circuits in the vehicle.
OPERATION GUIDE
To select your suitable charging setting, please refer to the following table:
LCD Indicator Application
AGM SPIRAL, AGM FLATPLAT batteries
SLI(Flooded), EFB, CAL/CAL, VRLA and most of MF batteries
GEL batteries
LFP(LiFePO4) batteries
CAUTION: Please do not select AGM/STD/ GEL to charge LFP battery. This may cause
batteries to burst, which can result in damage or injury to a person or property.
RISK OF DAMAGE!
Small battery mode
Output: 1.5A for 12V batteries
Use for smaller batteries. 2.3Ah to 30Ah
Large battery mode
Output: 10A for 12V batteries
Use for large batteries. 30Ah to 200Ah
Power supply function: 13.6V – 10A this function is used to keep the vehicle-
computer memory active while the battery is being changed or whenever the
battery is disconnected from the vehicle's circuit. CAUTION: IN THIS FUNCTION,
THE BATTERY CHARGER IS NOT being PROTECTED AGAINST POLARITYREVERSAL.
RISK OF DAMAGE!
7
Vedpak 215_Version 1_10.2016