Acqua Brevetti BravoMATIC Série Manuel D'instruction page 45

BravoMATIC - ENGLISH
Install the filter respecting the direction of the water flow indicated by the stamped arrow.
Installation 1. Installation 2.
Inlet from the right Inlet from the left
Outlet from the left Outlet from the right
If the orientation of the mounting plate is changed in a different manner with regards to the one supplied
by the manufacturer, proceed as follows:
Unscrew the filter plate tightening nuts and remove them (with a No. 6 Allen wrench);
Orientate the plate in the desired position respecting the arrow indicating the water inlet direction, taking
care to correctly position the shaped white gasket between the brass plate and the white acetal resin head.
Insert the plate into the filter body, tighten the tightening nuts in a homogeneous manner, compressing the
gasket.
Any other configuration may result in the incorrect operation of the equipment.
In case of doubt, contact Acqua Brevetti SRL (tel.: +39.049.8973432 or e-mail: info@acquabrevetti.it).
B1.8 Installation of the backwash solenoid valve (optional)
The closing solenoid valve must be installed on the filter outlet connection
(see item 8 of the example B of the installation diagrams).
To manage the closing solenoid valve, the control panel is required
(see item 9 of the example B of the installation diagrams). The manufacturer makes available the optional
control panel (code 23022030).
MAN139 PAGE E-18