Base Camp F235896 Instructions Pour L'utilisateur page 9

SET UP INSTRUCTIONS FOR YOUR AqUACUBE®
1
2
3
STEP 1.
Remove all components from the storage
bag and place the appliance on a solid,
non-combustible surface and straighten
out all hoses to remove any kinks or twists.
STEP 2.
Check that the power switch is "oFF" then
connect the pump assembly to the water
inlet and the power lead to the outlet
marked "PUMP".
STEP 3.
Attach the gas cartridge to the regulator by
rotating in a "clockwise" direction then
attach the regulator to the Aquacube.
Check for gas leaks with soapy water –
Do not use a flame.
If a leak is detected remove the gas
cartridge & retighten all connections,
then retest.
STEP 4.
Submerge the pump in a suitable reservoir
of water, Do not use water direct from
rivers, lakes or the ocean. Do not use
salt water with this appliance.
4