Base Camp F235896 Instructions Pour L'utilisateur page 10

AqUACUBE® SHOWER OPERATING INSTRUCTIONS
1
2
3
open Flow regulation switch
4
ensure Gas
control is
in central
position
5
6
OPERATING THE SHOWER
Step 1. Press the Power Button and the unit will switch on and
automatically selects the shower outlet.
Step 2. Check the Battery Indicator to see if sufficient power is available,
if not connect to the AC or DC adaptor.
Step 3. Attach the shower hose using the Quick Connect Fitting, and
ensure that the Flow Switch on the shower head, is in the
"open" position.
Step 4. Position the gas control in the central position, then depress the
Pump Button, water will start to flow within a few moments.
Step 5. The electronic ignition should be heard igniting the burner,
when lit, the "Flame" icon on the display will illuminate and the
outlet water temperature read out will increase.
Step 6. Taking care to measure the temperature of the water from the
shower head, the temperature can be adjusted by turning the
gas control until the desired level is reached.
Step 7. The water flow can be stopped at any time by sliding the
Flow Switch to the "oFF" position, the burner will
extinguish and the pump will continue to operate.
Step 8. To reignite the burner, slide the Flow Switch to the "on" position
and water will flow from the shower head and the burner will
reignite within 5 to 10 seconds.
iMportant – water remaining in the heat exchanger while the
flow is stopped may become hot. when the flow is resumed the
user must check the temperature output to ensure that it is
suitable and not too hot.
Once the user has finished with the appliance, slide the Flow
Switch to the "OFF" position and depress the "PUMP" button to
stop the flow of water to the appliance.
7 8