Install The Ups; Rack-Mount Installation; Tower Installation - INFOSEC UPS SYSTEM E6 LCD RT Evolution Manuel De L'utilisateur

2.2 Install the UPS

Rack-mount installation

Step 1: Attach mounting ears to the side mounting
holes of UPS using the screws provided and the ears
should face forward.

Tower installation

The UPS system is shipped with four plastic feet and 6 plastic extensions (2 short extension plus 4 long extensions). Those
can be used to tower install the UPS power module in 3U or UPS power module with one battery bank in 6U.
To install in 3U, it's not necessary to use long extensions.
Step 1

Assemble two feet and one
short extension together as
one supporter with 13cm
width available. Another
supporter could be
assembled in same method
To install in 6U, it's not necessary to use short extensions.
Step 1

Assemble two feet and
two
together. Then, one set
of plastic supporter with
26cm
Another set of supporter
could be assembled in
same way.
8
Step 1


Align the two stands
approximately 35cm apart in step
2.

long extensions
Align the two stands approximately
width is done. 35cm apart in step 2.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr –

Step 2: Lift the UPS module and slide it into rack
enclosure. Attach the UPS module to the rack
with screws, nuts and washers (user-provided)
through its mounting ears and into the rack rails.
Step 2
Step 2
Step 2
Step 3

Then, put UPS module in the
stands as shown in step 3. Be
sure that the LCD of UPS should
be on upper half part of front
panel.
Step 3

Then, put UPS module and battery
bank in the stands as shown in step 3.
Be sure that the LCD of UPS should be
on upper half part of front panel.
XX 05 XX 16 XX AA XX 59 XX205 03