Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
connected to an AC supply.
1.3 Maintenance Warnings
Service and repair should be done only by trained personnel. During any service work to the UPS, it should be turned
off or manually bypassed. Note that potentially lethal voltages exist within this unit as long as the battery supply is
connected.
Your UPS power module and battery module(s) do not require routine maintenance. Do not open them for any reason.
There are no user-serviceable parts inside.
Even after the unit is disconnected from the mains, components inside the UPS system are still connected to the
battery packs which are potentially dangerous.
Before carrying out any kind of service and/or maintenance, disconnect the batteries and verify that no current is
present and no hazardous voltage exists in the terminals of high capacity capacitor such as BUS-capacitors.
Fuses should be replaced only by factory authorized personnel. Blown fuses should be replaced only with fuses of the
same number and type.
Verify that no voltage between the battery terminals and the ground is present before maintenance or repair. In this
product, the battery circuit is not isolated from the input voltage. Hazardous voltages may occur between the battery
terminals and the ground.
1.4 About batteries:
Do not operate your UPS without connecting it to an external battery module.
Batteries can present a risk of electrical shock and burn from high short-circuit current. Observe proper precautions.
a) Remove watches, rings, or other metal objects
b) Use tools with insulated handles.
c) Wear rubber gloves and boots.
d) Do not lay tools or metal parts on top of batteries.
e) Disconnect charging source prior to connecting or disconnecting battery terminals.
Do not dispose of the batteries in a fire. Do not open the UPS or batteries. The batteries must be rightly deposed
according to local regulation.
Do not short or bridge the battery terminals with any object.
Unplug and turn off the UPS before performing battery replacement.
Battery replacement should be performed only by authorized service personnel using the same number and type of
batteries (Sealed Lead-Acid). Use tools with insulated handles. The batteries are recyclable.
Do not open or mutilate the batteries. Released electrolyte is harmful to the skin and eyes, and may be toxic.
Do not connect or disconnect battery module(s) while the UPS is operating from the battery supply.
1.5 Standards
* Safety
Safety Conformance: IEC/EN 62040-1,UL1778 (4th Edition)
Safety Markings :, cTUVus, CE
* EMI
Conducted Emission...............................:IEC/EN 62040-2
Radiated Emission..................................:IEC/EN 62040-2
*EMS
ESD.........................................................:IEC/EN 61000-4-2
RS........................................................ ...:IEC/EN 61000-4-3
EFT......................................................... :IEC/EN 61000-4-4
SURGE................................................... :IEC/EN 61000-4-5
CS........................................................... :IEC/EN 61000-4-6
Power-frequency Magnetic field.............. :IEC/EN 61000-4-8
Low Frequency Signals............................:IEC/EN 61000-2-2
Warning: This is a product for commercial and industrial application in the second
environment-installation restrictions or additional measures may be needed to prevent
disturbances.
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr –
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Category C3
Category C3
Level 4
Level 3
Level 4
Level 4
Level 3
Level
4
05 16 AA 59 205 03XX XX XX XX XX
3
Publicité
Table des Matières
Dépannage
