INFOSEC UPS SYSTEM E6 LCD RT Evolution Manuel De L'utilisateur page 13

3-7. LCD Operation
The entire LCD structure is demonstrated as diagram below:
Press either button"UP"or "DOWN"
Main Interface
Press button"ESC"
3-7-1. Main interface (home page)
1) In the first line, it will display the UPS running status mode;
2) When alarms happen, the warning or fault information will display below the "load" line;
3) When the front panel is not operated for 10 minutes, the display page will return back to home page;
4) Press the "UP" or "DOWN" button to enter the operation menu (see 3-7-2-1);
5) When it displays home page in LCD, if UPS is in bypass, you could press the "ON/ENTER" button to turn on the UPS to
AC / converter / ECO / battery mode according to the setting and input status; in reverse, you could press the
"OFF/ESC" button to allow UPS to bypass mode or shut down. (Refer to section of "Single UPS Operation").
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr –
Control
Measurement
Information
Setting
Alarm
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Turn On
Press button"Enter"
Batt Test
Press button"Esc"
Mute
Para Unlock
Page 1: Input
Page 2: Output
Press button"Enter"
Page 3: Battery
Press button"Esc"
Page 4: Bypass
Page 5: Charger
Page 1: Bypass
Page 2: ECO
Press button"Enter"
Page 3: Output
Press button"Esc"
Page 4:Battery
Page 5: UPS Info
Page 6: Others
Bypass
ECO
Press button"Enter"
Output
Press button"Esc"
Battery
Calibration
Others
Press button"Enter"
Fault Info
Press button"Esc"
Warning Info
05 16 AA 59 205 03XX XX XX XX XX
13