Changing The Tool - KRESS 650 SBLR-1 Mode D'emploi

Operation
-Note-
The changeover must not be done at full load or
maximum speed.
In this way, you can increase the life of your
machine.
Select the direction of rotation
Operate the rotational direction switch IV only
when the machine is at a standstill!
Grip the rotational direction changeover switch IV
on both sides and set the required direction of ro-
tation.
Clockwise rotation:
For drilling and fixing screws.
Anticlockwise rotation:
For loosening and removing screws
and nuts.
Important: Press the rotational direction switch IV
up to the stop on the housing, i. e. until it engages
audibly.
The machine cannot be switched on if the revers-
ing switch is in centre position.
Selecting the modes of operation
With the drilling / percussion drilling II changeover
switch, you can switch the hammer mechanism on
and off.
Drilling and fixing screws
Drilling and fixing screws
Percussion drilling
Percussion drilling
The changeover switch engages audibly and can
be actuated when the machine is running.
-Note-
Percussion drilling and drilling only in a clockwise
direction!

Changing the tool

Disconnect the plug from the power
source before making any adjust-
ments, changing accessories, or stor-
ing power tools.
Such preventive safety measures
prevent accidental start of the power
tool.
Wear safety gloves for tool chang-
ing.
The tool insert can become very hot
after working for long periods and/or
the cutting edges of the tool insert
are sharp.
Quick action chuck with ASL
The drill spindle stops if the On/Off switch is not
pressed. This enables quick, convenient and easy
changing of the insertion tool in the drill chuck.
Mounting the tool
Turn the sleeve of the quick action drill chuck
manually until you can no longer hear a "click".
The drill chuck is locked automatically.
Removing the tool
Open the sleeve anticlockwise until the tool can be
removed.
Toothed ring drill chuck
Mounting the tool
Insert tool. Fix the tool by turning at the toothed
ring.
Insert the drill chuck wrench into one of the three
holes on the toothed ring drill chuck and tighten
clockwise.
Remove the drill chuck wrench.
Removing the tool
Open toothed ring drill chuck with drill chuck
wrench and remove tool.
Remove the drill chuck wrench.
-Note-
Do not fix drill chuck wrench on the drill with
chains, strings or similar means.
The drill chuck wrench could get caught in mov-
ing parts and lead to injuries.
English 19
EN
SBM-EN/0802