BFC LEVETTA Mode D'emploi page 10

Periodic MAINTENANCE ... continued
Replace the normal filter in the filter holder with a blind filter (without holes), pour a
teaspoonful of detergent into the blind filter and insert the filter holder (10) into the
unit head. Start dispensing (9) as if making coffee. Stop after 15 seconds. Mixed water
and foam will flow out the drain valve into the drip tray (11). Continue dispensing
until the water flowing out the drain valve is clear. At the end of this process, replace
the blind filter with the correct normal filter with holes and dispense water several times
to rinse the filter holder and the unit head.
It is advisable not to drink the first coffee that is dispensed. To clean the filter holder
and the filters, leave them to soak for at least 30 minutes in a solution of hot water and
detergent prepared in a plastic or stainless steel container. Rinse them with clean water.
Frequent cleaning allows a smooth coffee to be obtained as well as prolonging the life
of your coffee maker.
INSTALLATION
1. Remove the outer packaging, checking imme-
diately that the appliance is intact and has not
been damaged in any way. Adjust the feet until
the appliance is level. Make sure that the mains
voltage corresponds to details given in the specifi-
cations.
2. Place the appliance on a sturdy and level table
or counter, near the electrical socket so that the
plug is easily accessible.
INTERNAL TANK
1. Fill the tank located under the upper lid (12)
with approx. 3 litres of water.
2. Put the ON/OFF switch (3) to ON. The red
indicator light (4) comes on.
3. The appliance starts to fill with water automa-
tically until the set level is reached (level sensor in
boiler).
Wait approx. 15-20 minutes to allow the applian-
3. Connect the approved cord H05VV-F 3G 1.5
mm with the SCHUKO (EUROPE) plug to the
electricity supply. Before switching the appliance
on, check that the socket has an EFFICIENT,
SAFE EARTH TERMINAL.
4. ONLY SWITCH ON THE APPLIANCE
AFTER HAVING FILLED THE CONTAINER
UNDER THE REMOVABLE LID (12) WITH
WATER.
ce to reach working temperature. The coffee
maker is ready for use when the green indicator
light (5) goes out.
4. The rear tank must be filled with water before
putting the on/off switch (3) to on.
sect. 2
Please read the
instructions written to
the side carefully.
sect. 3
sect. 4
Steam and hot water
are under pressure.
DANGER OF SCALDS
Page 2
The appliance will
start to fill with water
automatically until
the set level is rea-
ched.