Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
About the controls and settings.
Setting the Temperature Control
Display Panel
When the Wine Chiller is Plugged In
After plugging in the wine chiller and making your
temperature selection, allow the wine chiller to
reach the set temperature before loading your wine.
This may take up to 12 hours to completely stabilize.
After loading the wine, you may notice a rise in
the temperature. Allow adequate time for the
temperature to return back to the set temperature.
This may take up to 12 hours to completely stabilize.
When first powering on, the display screen
gives a full display for 3 seconds and the
start-up sound rings; then the machine enters
into operation in the locked state. See below
for unlocking instructions.
If there is no key operation for 30 seconds, the
display screen will turn off. The display screen
will turn on again, if you touch any key.
When powering on, the temperature of the upper
chamber will be adjusted according to the factory
pre-set. By pressing the Option key
Switching of the Fahrenheit temperature and Celsius temperature
Press the Temperature-rise key
the Temperature-drop key
time for 3 seconds to switch between Celsius
Lock/Unlock Key Button
By pressing the Lock/Unlock key
3 seconds, the buzzer rings and the locked
mode is activated; the temperature display
areas (digit display areas) of upper chamber
and lower chamber turn off.
By pressing the Lock/Unlock key
3 seconds in the locked mode, the buzzer rings
and the locked mode is de-activated; After
unlocking, the temperature display area of
selected chamber turns on.
NOTE: WHEN USING ANY COMPARTMENT FOR BOTH WINE AND BEER STORAGE WE RECOMMEND
THAT YOU PLACE RED WINE BOTTLES ON TOP SHELF AND BEER ON BOTTOM SHELF.
Upper chamber
Lock/unlock key
display area
Lighting mode key
at the same
Lower chamber
display area
Temperature-rise key
temperature area will be switched between upper
chamber and lower chamber. Once a chamber is
selected, the display will flash and at this time the
temperature of the chamber can be set up. After
locking, temperature display stops flashing.
By selecting the key
temperature areas (upper or lower chamber),
the temperature display of upper or lower
chamber flashes.
By pressing the Temperature-rise key
the temperature will increase 1°C (or °F). After
locking, the cooler will operate according to the
setting temperature;
By pressing the Temperature-drop key
the temperature will decrease 1°C (or °F). After
locking, the cooler will operate according to the
setting temperature
The wine cooler's temperature can be set
between 7~18°C (44~65°F).
, the
and
temperature and Fahrenheit temperature; the
screen will display the Fahrenheit temperature
or Celsius temperature under the current mode.
When in the locked mode, if you touch any
for
key besides the Light key
screen will keep flashing for 2.5 seconds and
the buzzer will ring, alerting you to unlock the
control.
for
Temperature-drop key
Temperature-area
option key
to switch the
, the display
,
,
5
Publicité
Table des Matières
