WAGNER AG-19 Mode D'emploi page 23

3. Insert the new tip into the slot on the tip guard. The arrow on the tip
handle should be pointing in the forward direction for spraying.
Removing the Seal and Tip seal
1. Remove the tip and tip guard from the spray gun.
2. Remove the seal and tip seal from the back of the tip guard.
Worn tips have a negative impact on the spray pattern and will
i
lead to increased material consumption and a smaller width of
the spray jet. Replace worn tips immediately.
Cleanup
A well-cleaned airless gun is essential for a satisfactory level of operational
quality. Flush the gun after each use and store in a dry location. Do not leave
the gun or any of its parts in water or solvents.
Special cleanup instructions for use with flammable solvents:
• Always flush spray gun preferably outside and at least one hose length
from spray pump.
• If collecting flushed solvents in a 5 litre metal container, place it into an
empty 20 litre container, then flush solvents.
• Area must be free of flammable vapors.
• Follow all cleanup instructions.
The spray device, the hose and the airless gun have to be
cleaned thoroughly after using, as otherwise the paint that was
used can accumulate and considerably impair the performance
Attention
of the device.
Always spray at the lowest possible pressure when the tip and
tip guard have been removed. To clean the airless gun, hose and
spray device, use only water or a suitable solvent.
AG 19
GB
23