About This Guide - Radiodetection RD5100 H2O+ Guide D'utilisation

Preface

About this guide

CAUTION: This guide provides basic operating instructions for the RD5100H
locator and transmitter. It also contains important safety information and guidelines and
as such should be read in its entirety before attempting to operate the RD5100H
locator and transmitter.
This guide is intended as a quick reference guide only. For detailed instructions, including
the use of accessories, please refer to the RD5100H
is available for download from www.radiodetection.com.
Certificates of conformity for the RD5100H
found at www.radiodetection.com.
WARNING: Direct connection to live conductors is POTENTIALLY LETHAL. Direct
connections to live conductors should be attempted by fully qualified personnel only
using the relevant products that allow connections to energized lines.
WARNING: The transmitter is capable of outputting potentially lethal voltages.
Take care when applying signals to any pipe or cable and be sure to notify other
technicians who may be working on the line.
WARNING: Reduce audio level before using headphones to avoid damaging your
hearing.
WARNING: This equipment is NOT approved for use in areas where hazardous
gases may be present.
WARNING: When using the transmitter, switch off the unit and disconnect cables
before removing the battery pack.
WARNING: The RD5100H O+ locator will detect most buried conductors but there
2
are some objects that do not radiate any detectable signal. The RD5100H
other electromagnetic locator, cannot detect these objects so proceed with caution.
There are also some live cables which the RD5100H
Power mode. The RD5100H O+ does not indicate whether a signal is from a single
2
cable or from several in close proximity.
WARNING: Batteries can get hot after prolonged use at full output power. Take
care while replacing or handling batteries.
O+
2
O+
2
O+ locator operation manual, which
2
O+ locator and transmitter can be
2
O+, or any
2
O+ will not be able to detect in
2
2
3 Year Extended Warranty
The RD5100H O+ locator and transmitter are covered by a 1 year warranty
2
as standard. Customers can extend their warranty period to a total of 3 years
by registering their products within 3 months of purchase.
Visit https://portal.radiodetection.com/ to create your company portal
account, and use the Product page to register your locator or transmitter.
Information on how to create a company account can be obtained from:
https://support.radiodetection.com
From time to time Radiodetection may release new software to improve the
performance or add new functionality to its products. By registering, users will
benefit from email alerts advising about new software and special offers related
to its product range.
Users can opt-out at any time from receiving software and technical
notifications, or just from receiving marketing material by contacting
Radiodetection.
eCert and Self-Test
The RD5100H O+ locator is safety equipment which should be regularly
2
checked to ensure its correct operation.
eCert provides a thorough test of the RD5100H
1
supplies a Radiodetection Calibration Certificate when a positive test result is
obtained.
Refer to the RD5100 Manager operation manual for further details. Additional
1
purchase may be required.
RD5100H O+ locators incorporate an Enhanced Self-Test feature. In addition
2
to the typical checks for display and power functions, the RD5100H
test signals to its locating circuitry during a Self-Test to check accuracy and
performance.
We recommend that a self-test is run at least weekly, or before each use.
1 Contact Radiodetection for eCert and RD5100 Manager availability.
O+'s locating circuitry, and
2
O+ applies
2
3