Care And Maintenance - Radiodetection RD5100 H2O+ Guide D'utilisation

Using iLOC
The locator and transmitter need to
be paired to use iLOC. For optimum
performance:
• Try to minimize obstructions in line of
sight
• If possible, raise the transmitter off
the ground by 30-60cm (1-2ft)
• Face the rear end of the transmitter
towards the locator
• Point the screen of the locator
towards the transmitter.
NOTE: If any iLOC commands fail, move closer to the transmitter and repeat the
process.
Changing frequencies
Once the transmitter and the locator are paired, you can change the transmitter's
output frequency remotely using the locator:
1. On the locator, select the frequency you want by pressing the
frequency is displayed on screen.
2. Press the key to send the new frequency to the transmitter.
3. The locator will display SEND momentarily and then OK if the transfer is
successful.
4. If the transfer is unsuccessful, the locator will display a bluetooth error code error
code (see operation manual for details).
If the process fails, you may be out of range or there may be an error in the connection.
Move closer to the transmitter and retry the procedure. If the connection continues to
fail, return to the transmitter and reset the connection.
Adjusting power
iLOC lets you adjust the transmitter's power output remotely; you can also put the
transmitter into standby mode and then wake it remotely.
1. Transmitter power options are located in the TXOUT menu on the locator.
Press and hold the
key to display the TXOUT menu.
2. Press the key to enter the power level menu.
3. Scroll up or down through the power output options using the
• STDBY: Transmitter standby mode, the connection is still active but the
output
is disabled – use to prolong battery life.
key until the
or keys:
18
• LOW: Low power output
• MED: Medium power output
• HIGH: High power output
• BOOST: Temporarily boosts transmitter power output to its maximum level.
4. Once you have selected the mode you want, press the
5. Press and hold the key to select the new setting and exit the menu.
6. Press the key once to send the settings to the transmitter.
NOTE: When changing the transmitter frequency using iLOC, the chosen
transmitter power setting will be retained.
Training
Radiodetection provides training services for most Radiodetection products.
Our qualified instructors will train equipment operators or other personnel at your
preferred location or at Radiodetection headquarters. For more information go to
www.radiodetection.com or contact your local Radiodetection representative.

Care and maintenance

The RD5100H O+ locator and transmitter are robust, durable and weatherproof.
2
However you can extend your equipment's life by following these care and
maintenance guidelines.
General
Store the equipment in a clean and dry environment.
Ensure all terminals and connection sockets are clean, free of debris and corrosion
and are undamaged.
Do not use this equipment when damaged or faulty.
Batteries and power supply
Only use the rechargeable battery packs, chargers and power supplies approved by
Radiodetection.
If not using rechargeable packs, use good quality Alkaline or NiMH batteries only.
Batteries should be disposed of in accordance with your company's work practice,
and / or any relevant laws or guidelines in your country.
key to confirm.
19