Loading Printer Paper - Tanita TBF-300A Mode D'emploi

7. Loading Printer Paper

Please change printer paper when red lines appear along the sides.
WEIGHT Kg
CLOTHES lb
MALE cm
FEMALE ft.in
ATHLETIC AGE
STEP ON % FAT
3cm
1inch
16
1. Turn the unit on by pressing the [ON/OFF] key.
When there is no printer paper in the feeder, "P-End" will
flash on the LCD.
If you do not want to use printer paper, press the [CE] key
to continue measurement with no printer paper. (refer to
P.28 Operating Instructions).
When there is no "P-End" message, but the printer fails to
print, the chosen number of print outs may be "0". Select
a number of print outs greater than "0". (see P.18 "Mode
Selection")
2. Remove the Paper Dispenser Cover by lifting it up from
the back.
3. In a straight line, cut approximately 1 inch (3cm) off of the
paper roll, this will ensure smooth feeding.
4. Insert the printer paper in the holder as displayed. Be sure
to feed the printer paper straight into the automatic feeder.
As the front edge of the printer paper enters the
appropriate slot, it will automatically feed. Once the
printer paper feeds, it will exit the printer paper feed slot
located on the printer cover, and be cut. Remove printer
paper from the Printer Cover.
5. Replace the Paper Dispenser Cover as displayed.
Please refer to P.34 for information on "Dealing with Paper
Jams".
Only use Tanita thermal paper. Tanita can not
guarantee the performance of the printer if
printer paper supplied from outside sources is
used.
17