Cal Settings Menu - DeFelsko PosiTector 6000 Guide D'utilisation

Coating thickness gauges. appareil électronique portable qui mesure de manière non-destructive et de façon rapide et précise l'épaisseur des revêtements sur tous les métaux

Masquer les pouces Voir aussi pour PosiTector 6000:

Notice d'instruction (61 pages)

Guide rapide (46 pages)

Mode d'emploi (21 pages)

Table des Matières

Les langues disponibles

Where a Cal adjustment method has not been specified, use

a 1-point method first. If measuring the included shims on your

surface reveals inaccuracies, use the 2-point method. Factory

Cal settings can be restored at any time by performing a Reset

(pg. 4), creating a NEW Cal setting (See Cal Memory, pg. 4),

or by DELETING the adjustments made to the Cal 1 calibration

setting (pg. 4). The

whenever factory Cal settings are in use.

With "FN" Gages, calibration adjustments are made only to

the "F" or "N" mode (stored independently under a particular Cal),

whichever was measured last.

1 Pt Adjust

or correction value, there are 4 ways to perform this:

(i) Simple Zero Adjustment- Measure your uncoated part.

Lift the probe and adjust to "0" using the ( + ) and

(ii) Average Zero Adjustment

to (i) is to average 3 to 10 measurements on the uncoated part.

(iii) Simple Adjustment to a Known Thickness- Measure a shim

of known thickness placed on the uncoated part. Lift the probe

and adjust to the shim thickness using the ( + ) and

(iv) Average Adjustment to a Known Thickness

A preferred method to (iii) is to average 3 to 10 measurements

of a shim of known thickness placed on the uncoated part using

the ( + ) and

(-)

2 Pt Adjust

Provides greater accuracy within a limited, defined range.

Measure a thin value (often zero) and a thicker value.

These values should bracket your expected thickness range.

Cal Lock

When checked, the

are "locked" to prevent further user adjustments.

symbol appears on the display