Applications - IMG STAGELINE TXS-875B Mode D'emploi

Pair of Antenna Signal Amplifiers
These instructions are intended for users without
any specific technical knowledge Please read the
instructions carefully prior to operation and keep
them for later reference
1 Overview
1
1 Power LED
2 BNC jack OUTPUT, to route the amplified an-
tenna signal to the receiver
3 16 mm (
mounting bracket (5) or a microphone stand
4 BNC jack ANT, to insert the antenna
5 Mounting bracket
6 Mounting screw, to fasten the amplifer

2 Applications

The pair of antenna signal amplifiers TXS-875B
is suitable for the receivers of the wireless micro-
phone systems TXS-... which are equipped with
BNC antenna jacks The amplifiers are designed
to improve the interference resistance and to
increase the transmission range Depending on
local conditions, it will be possible to double or
triple the range In addition, they can be used to
compensate signal loss occurring in combination
with long antenna cables
TXS-875B consists of two amplifiers and two
mounting brackets Connect the amplifiers either
directly to the receiver or via the antenna splitter
TXS-875DS The jack OUTPUT (2) is used to sup-
ply the amplifiers with power from the receiver
or the splitter
Two amplifiers can be cascaded to increase
the gain and thus the range (refer to the figure
below) The supply voltage will then be internally
routed from the jack OUTPUT to the jack ANT (4)
6
2
⁄ ") threaded hole, to screw on the
5
8
Increasing the gain
with two signal amplifiers
ANT
ANT
3 4
ANT
5 6
Antenna
input