Joannes G50/2 oil Notice D'utilisation Et D'entretien page 63

pag. 62
The burner shall be fed by the kind of fuel it was intended as shown on its data plate with the technical features mentioned
in this manual. The line of the fuel feeding the burner shall be perfectly sealed. Also it shall provided with all the control
and safety devices in compliance with the regulations in force. Make sure that no external materials enter the line during
the installation.
Make sure that the electric system is in compliance with the features shown on the data plate and this Manual. The burner
shall be properly connected to safe earthing system, in compliance with the regulations in force. In cas of doubt, ask
qualified personnel to accurately inspect the installation.
Do not exchange the cables of the neutral with the cables of the phase.
The burner could be connected to the electric network by a plug-socket connection, only if this is provided in such in a
way that the configuration of the coupling prevents the reversal of the phase and of the neutral. Install a service switch
in the control panel for the heating unit, in compliance whit the current regulations.
The whole electric system and all the sections of the cables shall be adequate to the maximum value of power absorbed
and shown in the data plate an in this manual.
The feeding cable shall be replaced by qualified personnel only.
Never touch the burner with wet parts of the body or barefooted.
The length of the cables shall allow the opening of the burner and of the boiler door.
The electric connections shall be affected by qualified personnel only and in compliance with the regulation in force.
After removing the packing material, make sure that the contents has suffered no damage. In case of doubt, do not use
the burner and contact the supplier. The packaging material (wooden crates, paperboard, plastic bags, foamed polystyrene,
etc.) represents a pollution form an may become a source of hazard. It shall be gathered and disposed in a proper way.