Troubleshooting - Waring Commercial WFP11SW Mode D'emploi

TROUBLESHOOTING

This section describes potential problems and the correct
solutions for them. Problems that cannot be solved with the
guidelines listed below should be referred to one of the Waring
Authorized Service Centers for assistance. A listing of authorized
service agencies is supplied with each Waring Commercial food
processor.
Unit does not start when assembled correctly
• Pull the plug and try plugging into another outlet.
• Turn ON lever to On.
• Make sure the bowl is properly positioned on the motor base,
that the bowl or cover is on properly, and that the safety
interlock tab on the cover has properly engaged the safety
interlock switch.
Unit stops running during processing
• The unit may have overheated. Refer to Resetting Thermal
Protection section (page 13).
• Turn unit off and unplug.
• Remove bowl attachment.
• Remove food being processed from inside the bowl.
• Allow unit to cool for 5 minutes.
• Reassemble unit, and run first with the bowl empty, then add
food back into the bowl and try again.
Unit will not come up to full speed
• Bowl is overloaded – remove food being processed and
reload using smaller quantities.
If unit does not operate after you have followed the
above
• Check outlet to be sure there is current.
• Check to be sure circuit breaker is on.
• Check to be sure the fuse is not blown if there are fuses
on this circuit.
16
• Call local authorized Waring service agency.
If unit starts to spark or smoke
• Turn unit off, unplug it, and call local factory-authorized Waring
service agency.
If food processor makes grinding noise
• Turn unit off, unplug, disassemble, check bowl and blade to
see if they have been rubbing together.
• If bowl and blade are rubbing, call your authorized Waring
service agency.
17