Part Names And Functions - Audio-Technica AT-LP3 Manuel De L'utilisateur

Part names and functions

Overall diagram
5
1
2
3
4
8
45 RPM adapter (shown in receptacle)
1
Select the platter speed (33-1/3 or 45 RPM).
Platter
2
Rubber mat
3
Spindle
4
Dust cover hinge holders
5
Attachment points for dust cover hinges.
Tonearm part
6
For details, refer to "Tonearm" on p. 5.
Size selector
7
Switch between 12" and 7", according to the size of the record.
Platter speed button
8
Select the platter speed (33-1/3 or 45 RPM).
START button
9
Spins the platter and moves the tonearm.
STOP button
10
Returns the tonearm to its original position and stops the platter.
11
9 10
Dust cover
11
Pre-amplifier selector switch
12
If using an amplifier with a PHONO input jack, set this switch to the
PHONO position. If connecting to the AUX jack of an amplifier, set this
switch to the LINE position.
MM (VM)/MC cartridge selector switch
13
If using an MM (VM) cartridge, set this switch to the MM position. If
using an MC cartridge, set this switch to the MC position.
RCA audio cable (with grounding wire)
14
Connect to PHONO input jack (grounding wire to ground terminal, if
available) or AUX (LINE) input jack of a receiver, amplifier or other
connectable equipment.
AC inlet
15
Insert the power cable here.
5
6
7
12 13 15
14
E
N
4