Basic Function; Delete Accessories - König SAS-ALARM400 Manuel De L'utilisateur

SAS-ALARM400 - QIG
Main unit
Installation
Place the main unit with included double sided adhesive tape on the inside of the
doorframe. Place the small magnetic part on the door itself, a maximum of 10 mm away
from either side of the main unit. When the LEDs and tones are getting weaker, replace
the batteries.

Basic Function

1. ARM: Short press arm button (C). A single beep will sound.
2. DISARM: enter the 4 digit pincode in quick succession (default = 1234). Two beeps
indicate successful disarming. Three tones indicate false pincode. when typing a
wrong button, press arm button to reset entered pincode.
3. Use slide A to choose between OUT (30 second delay before arming or sounding the
alarm) or HOME (immediate arming).
4. Use slide B to choose between ALARM (2 minutes) or DOORBELL
Add accessories (only possible while disarmed)
Add remote control (SAS-ASRC4xx) (max. 10)
1. Long press the arm button on the main unit (4 LEDs light up)
2. Press any button on the remote control.
a. Two flashes and two tones indicates successful pairing.
b. Single flash and tone indicates failed pairing.
c. Three flashes and tones indicates no more remotes can be added
Add detector (SAS-ASDW4xx / SAS-ASMS4xx) (max. 10 per zone)
1. Long press the numbered button (1 - 4 matching the zone you want to add the
detector to) on the main unit (the corresponding LED lights up)
2. Power and/or trigger the detector you want to add
a. Two flashes and two tones indicates successful pairing.
b. Single flash and tone indicates known accessory.
c. Three flashes and tones indicates no more detectors can be added
3. When a detector is triggered, the corresponding zone indicator LED will flash

Delete accessories

Delete all remote controls (SAS-ASRC4xx)
1. Long press the arm button on the main unit (4 LEDs light up)
2. Long press the arm button on the main unit again.
3. 5 flashes and 5 tones means all remote controls have been removed.
4