Sharp AQUOS AN-65AG1 Mode D'emploi page 20

Installing the wall-mount bracket (Continued)
Connect the system cables and power cord to the terminals on the back
4
of the Liquid Crystal Television.
• For the LC-65GE1 integrated type, refer to page 8 (Model 65 inch integrated type).
Use the cable holder at the center of the back of the Liquid Crystal Television and the
5
cable holders holding the speaker cables to connect the system cables.
Surround the system cables.
(1) Pass through
the band.
(2) Pull the band
forward and
catch it on
the hook.
Remove the screw hole plugs (4 plugs) of
6
the wall-mount bracket on the back of the
TV and then screw in the 4 wall-mount
bracket unit screws (hexagonal socket
screws, M10 length: 30 mm) that are in-
cluded with the wall-mount bracket unit.
Carefully keep the removed screw hole plugs.
E-6
System cables
Cable holders
Screw hole plugs (4 plugs)
Power cord
Included part
Allen wrench
Hexagonal socket screws
(M10 length: 30 mm)
Mark A
Included hexagonal socket screws (4 screws)
Use an Allen wrench to screw in the included
hexagonal socket screws into the Mark A holes.
Wall-mount bracket