Wall-Mount Bracket Installation - Sharp AQUOS AN-65AG1 Mode D'emploi

Wall-Mount Bracket Installation

• To ensure safety, design and perform mounting location reinforcement so that it can withstand the weight
Caution
of the Liquid Crystal Television and the wall-mount bracket.
■
The LC-65GE1 (Separate type) is used as an example for the following explanation. The procedure is the same
for the LC-65D90U (Integrated type).
Determine the location where the base bracket will be
1
installed.
(1) Use tape or other means to mark the measured positions
on the wall where the display will be installed. The center
of the "X" drawn from the four corners of the square marks
the center of the panel.
(2) Take the plumb bob with the string and align it vertical to
the base bracket.
Use a pencil, etc., to mark the two screw hole locations.
Dimension lines
used as a guide
Base
bracket
outline
*When marking on the wall, use a material that will not leave a permanent mark on
the wall and get the approval of the customer before beginning the work.
Tighten the screws
2
Temporarily remove the base bracket from the wall and loosely screw in off-the-shelf screws (8
mm dia. × 2 screws (M6 length; At least 40 mm)) in the screw hole positions marked on the
wall. At this time, the screw heads should extend more than 4 mm above the wall so that the
base bracket can be hung on the screw heads. Hang the base bracket on the installed screws,
check to make sure the bracket is not sagging to the left or right, and then firmly tighten the
screws. Use off-the-shelf screws to secure the remaining screw holes (15 screws). (The screw
hole diameter is 9 mm. Use M8 (5/16") screws at least 40 (1 9/16") mm in length.)
E-4
Cellophane tape, etc.
String
Center
line
Weight
1572mm
(61.9 inch)
Min. 4mm
shaped screw holes
Use a pencil, etc., to
mark the screw hole
position on the wall
behind the bracket.
Position the base
Display
bracket so that the
outline
center of it is aligned
with the string.
Use the plumb bob with the
string used in Step 1 to make
sure the bracket is vertical.
Included part
Base bracket
Cellophane tape, etc.
Wall-mount bracket
unit installation hooks
Position the base
bracket so that the
vertical parts of it
are parallel with the
string.