Technical Specifications - Arcam DT91 Manuel

Technical specifications

Digital audio output
Format
Sample rate
Output impedance (co-axial)
Analogue audio output
Connectors
Output level
Output impedance
Minimum load
Frequency response (±0.5dB)
RF performance (DAB mode)
Tuning range
Sensitivity (VHF measurement to EN50248)
Audio data rate (maximum)
RF performance (FM mode)
Tuning range
Sensitivity (IHF)
Signal to noise ratio
THD+n
Aerial
Connector
Impedance
Remote control interface
Remote bus input
Serial port
General
Supply voltage
Power consumption
Size
Weight
Supplied accessories
E&OE
Note: All specification values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and specifications
are subject to change without notice.
SPDIF co-axial to gold-plated phono sockets
SPDIF optical to TOSLINK
48kHz (DAB mode)
32kHz (FM mode)
75Ω unbalanced
Two pairs of stereo outputs to gold-plated phono sockets
2.4Vrms at 0dB FS (DAB mode)
0.9Vrms at full modulation (FM mode)
<100Ω
600Ω
20Hz–20kHz
174–240MHz (Band III)
1452–1492MHz (L band)
better than –91dBm, typically –97dBm
224kbits/s at MPEG protection level 3
87–108MHz
3µV typical
65dB at full modulation, 1kHz
0.1% at full modulation, 1kHz
F type
50Ω
36kHz modulated RC5 on 3.5mm mono jack socket
RS232 to 9-way male D connector, DTE pin out. Remote
control codes given in table on following page.
115 or 230Vac, set by rear panel voltage selector switch
<20W
W435 x D320 x H83mm
3.6kg (net), 6kg (packed)
CR-389D remote control
two x AAA batteries
Mains lead
Indoor ribbon aerial
DT91
E-9