The Cr-389D Remote Control - Arcam DT91 Manuel

The CR-389D remote control

Use this button to switch between FM and
DAB mode. The LED above the
button is lit briefl y when the button is
pressed to show which mode is selected.
These buttons allow access to individual preset
stations. To select a preset press the corresponding
button. For presets 9 to 16, press and hold the
corresponding preset button for two seconds.
This button has the same function as
DISPLAY MODE
These buttons offer basic control over
DT91
E-8
FM/DAB
FM/DAB
Preset memory buttons
MODE
on the front panel.
Amplifi er controls
Arcam amplifi ers.
MENU
This button has the same function as the
button on the front panel of the tuner.
MENU
TUNER
FM DAB
FM
MENU DISP
DAB
1-9 2-10 3-11 4-12
5-13 6-14 7-15 8-16
MODE BAND
SP1
SP2
ENTER DISP
SEL
PHONO AUX CD TUNER
AV DVD VCR TAPE
AMPLIFIER
RPT
PROG DISP
CD
CR-389
DISP
This button toggles the tuner's display
between on and off.
TUNE buttons
These buttons enable you to scroll through the
available stations.
For more information on tuning radio stations
in, see the sections 'Searching for radio
stations: DAB' and 'Searching for radio
stations: FM' on page 6 and 7.
BAND
This button has the same function as
on the front panel.
SELECT
CD player controls
These buttons offer basic control over Arcam CD
players.
Note: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the tuner (where the
IR receiver is located), or the remote control may not
work.