Using Your Tuner; Front-Panel Controls; Searching For Radio Stations: Dab - Arcam DT91 Manuel

Using your tuner

Front-panel controls

Preset station selection
These buttons allow quick
selection of up to 16 preset
radio stations. For a preset
between 1 and 8, press
and release the appropriate
button – for a preset
between 9 and 16, press and
hold the appropriate button.
1–9
5–13
SEARCH
SEARCH
In DAB mode, pressing
scans for new
SEARCH
DAB radio stations. See
'Searching for radio
stations: DAB', for
further information.

Searching for radio stations: DAB

When using the DAB tuner section for the fi rst time, you should perform a search to fi nd the available
services in your area. You may also wish to repeat the search periodically to discover if any new
ensembles (i.e. groups of services) have gone on air, or if you move the tuner to a different area.
To perform a search
Ensure that the DT91 is in DAB mode (by pressing the DAB/FM button until 'DAB' is shown on the
display), then press
SELECT
search progresses.
A complete search may take three minutes or so to complete. You cannot cancel a search once started.
If no service is found after the search, then either your aerial is inadequate or you may be outside of the
area covered by DAB broadcasts. Please contact your Arcam dealer for further information or advice.
Selecting a service
Turn the rotary controller (or press
stations and to choose the one you wish to listen to. The service displayed will be selected automatically
after a delay of about two seconds.
Deleting services
Under normal circumstances, you should not need to delete services from the DT91. If you move to a
different region, however, or if a station ceases transmission, stations may be shown as available that
can no longer be received.
Individual stations cannot be deleted. To remove stations from the selection list that can no longer be
received, fi rst press the
control knob until the display shows 'DAB Setup: Press SELECT to erase', then press
are deleted.
A delete operation should always be followed by a search for available stations (as described previously)
DT91
otherwise no DAB radio stations will be available for selection.
E-6
2–10 3–11 4–12 MENU
SELECT
6–14 7–15 8–16
STORE STORE
1–8 9–16
STORE 1–8, STORE 9–16
These buttons are used
when specifying a preset
location (1–8 or 9–16) to
store a radio station. See
'Programming a preset
radio station', for further
information.
or ; the display shows 'DAB Setup: Press SELECT to scan'. Press
SEARCH MENU
to start searching for new stations. The current search frequency is shown on the display as the
4
button; the display shows 'DAB Setup: Press SELECT to scan'. Turn the
MENU
MENU
Opens the confi guration
menu for the DT91. See
the sections 'Searching
for radio stations: DAB'
and "Searching for radio
stations: FM", for further
information.
Control knob
In DAB mode, rotate the
control knob to cycle
through stations until the
one you wish to listen
to is displayed. In FM
mode, rotating the control
knob changes the tuning
frequency.
or on the remote control) to work through the available
3
SELECT
The button
SELECT
confi rms an action
within the confi guration
menu.
DISPLAY DAB/FM
MODE
DAB/FM
Switches between DAB
and FM mode.
DISPLAY MODE
Press this button to change
the type of information
shown on the display (such
as scrolling text or signal
strength).
. All services
SELECT
POWER
This switches the tuner
on and off. When the
tuner is switched on
the status LED is green.
DT91 FM + DIGITAL RADIO TUNER
POWER