ECG FT 33 Mode D'emploi page 19

FAN DESCRIPTION
1. Back and front cover grill
2. Fan blade
3. Base
ASSEMBLY
Notice: The fan may be used only if it is properly and completely assembled, including the base and the guard
grill. If you have any doubt, have the appliance inspected or assembled by a qualifi ed professional.
Stand
Fasten the motor assembly with the pedestal to the base using included screws A.
1.
Place the back part of the grill on the body of the motor B.
2.
Place the back part of the grill and tighten C.
3.
4. Place the fan blade on the shaft of the motor so that the notches correspond to the grooves on the shaft.
Secure with nut D.
Put the front grill on the back part of the grill and secure it using included screw E.
5.
USE
Make sure prior to each use that the fan is in good condition and the power cord is not damaged. The appliance
must not be used when the power cord is damaged.
You can control the fan using the control elements on the bottom part of the pedestal.
1. Plug the fan in the electrical outlet.
2. Set the speed by turning the control ring to the desired position to set the
optimum performance: 0 – off , 1 – low 2 – medium, 3 – high.
3. The control ring is located on the head of the fan. Start oscillation by
pressing the button. If you want to stop the fan turning left/right, pull the
button up.
If you do not use the device, always unplug the power cord from the outlet!
CLEANING AND MAINTENANCE
• Before cleaning pull out the plug of the power cord from the outlet!
• Use soft, dry cloth for cleaning. Do not use solvents or other chemicals.
• Make sure that no liquid seeped into the motor.
• If the fan is not used for long time, it is necessary to protect it from dust and moisture. We recommend that
you store it in its original packaging.
• When dismantling the fan, proceed in reverse order of the assembly.
We recommend to keep the packaging for possible transportation or storage of the fan.
GB
3 2 1 0
19