Electrolux EWB 105405 W Notice D'utilisation page 6

6 electrolux
• To cancel the delayed start and start the
cycle immediately, press "Start/Pause"
and then "Delay start"
"Start/Pause"
• To change the timer delay period, you
must go through the "Stop"
and reprogramme your cycle.
The lid will be locked during the delayed
start time. If you need to open it, you must
first pause the appliance by pressing the
"Start/Pause" pushbutton. After closing
the lid again, press the "Start/Pause"
pushbutton.
Time Manager
The cycle can be made longer or shorter by
using the "Time Manager"
The level of soiling of the laundry is also in-
dicated.
Soil level Icon
Intensive
Normal
Daily
Light
1)
Quick
1)
Super quick
1)
2)
Refresh
Super re-
2)
1)
fresh
1) To use on a half load.
2) The symbol flashes and disappears : this wash cycle
is a refresh cycle only.
The availability of these different levels var-
ies depending on the selected programme
type.
Start of the programme
Press the "Start/Pause"
start the cycle ; the corresponding light will
come on green. It is normal for the pro-
gramme selector to remain stationary dur-
ing the cycle. The symbol for the current
. Press
to start the cycle.
position
pushbuttons.
Type of fabric
For heavy soiled
items
For normal soiled
items
For daily soiled items
For slightly soiled
items
For very slightly
soiled items
For items used or
worn for a short time
For refreshing items
only
For refreshing a very
few items only
pushbutton to
cycle and the remaining time appear on the
display. If a delayed start has been selec-
ted, the countdown appears on the display.
Warming up
During the cycle, the
when the appliance is reaching the right
temperature.
Interrupting a programme
Adding washing
When the "Add washing" light
can add washing by proceeding as follows.
Press the "Start/Pause"
the corresponding light will flash green while
the appliance is paused. The lid can only be
opened around 2 minutes after the washing
machine has come to a stop. Press the
"Start/Pause" pushbutton again to con-
tinue the programme.
Modifying the programme in progress
Before making any changes to the current
programme, you need to pause the wash-
ing machine by pressing the "Start/Pause"
pushbutton. If the modification is not
possible, "Err" flashes in the display and the
"Start/Pause" pushbutton flashes red for
a few seconds. If you still decide to change
the programme, you must cancel the cur-
rent programme (see below).
Cancelling the programme
If you want to cancel the programme, turn
the programme selector to the "Stop" posi-
tion .
End of the programme
The washing machine stops automatically ;
the "Start/Pause"
and "0" flashes on the display. The lid can
only be opened around 2 minutes after the
washing machine has come to a stop. Turn
the programme selector to the "Stop"
position. Remove washing. Unplug and
close water inlet tap.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
symbol comes on
is on, you
pushbutton :
pushbutton goes out