Personalisation; How To Run A Wash Cycle - Electrolux EWB 105405 W Notice D'utilisation

4 electrolux
1. Programme selector
2. Pushbuttons and their functions
3. Display
4. "Add washing" light
5. "Start/Pause" pushbutton
6. "Time manager" pushbuttons
The symbols
1 2
Dispenser box

PERSONALISATION

Child safety
This option provides two types of locking :
• if the option is activated after the cycle
has started, no changes to the options or
programme is possible.
The cycle runs and you must deactivate
the option to run a new cycle.
• if the option is activated before the cycle
has started, the appliance cannot be
started.
To activate child safety, turn appliance on
and press "Extra rinse"
simultaneously until the confirmation
symbol shows on in the display. The ap-

HOW TO RUN A WASH CYCLE?

Using for the first time
• Ensure the electrical and water con-
nections comply with the installation
instructions.
• Remove the polystyrene insert and
all other items inside the drum.
3 4 5
Prewash
Wash
Softener (do not fill above the MAX symbol
and "Delay start"
1. Time manager
2. Temperature
3. Child safety
4. Cycle running :
Rinse, Drain,
5. Length of cycle or Timer delay count-
down
pliance memorises the selection of this op-
tion. To deactivate child safety, repeat the
process.
Audible signal
When the audible signal is activated, it
sounds when a button is pressed, at the
end of the programme, to indicate a fault.
To deactivate, turn appliance on and press
"Prewash" and "Extra rinse"
neously until the beep sounds. The signal is
only active if alarm sounds. To reactivate it,
repeat the same process.
• Run an initial wash cycle at 90°C,
without any washing but with deter-
gent to clean the water tank.
Prewash/Wash,
Spin
M
)
simulta-