Electrolux EWB 105405 W Notice D'utilisation page 11

malfunctions. The appliance can also be
damaged through physical contact.
Unpacking
1
3
Untying
4
1a
2a
3
To install your washing machine at the
same level as surrounding furniture, pro-
ceed as shown on picture 4.
2
4
1a 1b
2
1b
2b
4
Water supply
1
In case of necessity move the inlet hose in
the direction shown on picture no. 1. To
make this loose the inlet hose ring nut and
position the inlet hose downwards as
drawn on picture no. 1. Tighten the ring nut
back and make sure there are no leaks.
Open the water inlet tap. Check there are
no leaks. The water inlet hose can not be
extended. If it is too short, please contact
the after-sales service.
Drainage
Fit the U-piece on
the drainage hose.
Place everything in a
drainage point (or in
a sink) at a height of
between 70 and 100
cm. Ensure it is posi-
tioned securely. Air
must be able to en-
ter the end of the
hose, to avoid any risk of siphoning.
The drain hose must never be stretched. If
it is too short, contact an engineer.
Electrical connection
This washing machine must only be con-
nected in single-phased 230 V. Check the
fuse size: 13 A for 230 V. The appliance
must not be connected with an extension
lead or multi-plug adaptor. Ensure that the
plug is earthed and that it is in accordance
with current regulations.
Positioning
Position the appliance on a flat and hard
surface in a ventilated location. Ensure the
appliance does not come into contact with
the wall or other furniture. Accurate levelling
avoids vibrations, noise and prevents the
appliance from moving when running.
electrolux 11
2