Using Coffee Beans - Philips Grind&Brew HD7762 Mode D'emploi

5.2 Using coffee beans

Warning:
B
Always keep the water reservoir lid closed when
you fill the coffee bean container with coffee
beans. Otherwise coffee beans can fall into the
water reservoir and block up the water inlet.
Remove the coffee bean container
1
lid. (Fig. 12)
Fill the duo coffee bean container with
2
coffee beans. You can fill the duo coffee bean
container with two different types of coffee
beans. Make sure there are enough coffee
beans in the container for the amount of
coffee you want to brew (Fig. 13).
Note:
D
Always make sure the coffee bean container is
at least half full.
Warning:
B
To prevent the grinder from jamming, do
not use unroasted or caramelised beans.
We advise to use coffee beans instead of
espresso beans as this may cause damage.
To open the filter basket holder, pull at its tab
3
on the right side of the coffeemaker (Fig. 14).
Take a paper filter (type 1x4 or no. 4) and
4
fold the sealed edges to prevent tearing and
folding. Place the paper filter in the filter
basket. (Fig. 15)
Close the filter basket holder.
5
Put the jug in the appliance. (Fig. 7)
6
Turn the coarseness knob to select
7
the desired type of grind (from fine to
coarse). (Fig. 16)
Tip:
E
The coarseness knob allows you to
choose between nine different settings.
We preselected 3 optimal settings but you
can also choose any setting in between the
icons. We advise you to experiment with
the different grind settings to find out which
setting you prefer.
8
Turn the container selector to choose
8
between the two types of coffee
beans (Fig. 17).
Warning:
B
Whenever you switch between coffee bean
containers or coffee beans, there will always
be traces of coffee left of the previously
ground type of coffee beans. Clean the
coffee bean chute after you switch to a new
type of coffee bean to prevent this.
Note:
D
Depending on your taste, you can either
select one of the two types of coffee beans or
a mix of both types.
Press the on/off button on the front of the
9
appliance (Fig. 8).
• The number of cups starts to flash.
To select the number of cups, turn the knob
10
until the desired number of cups appears on
the display (Fig. 18).
Note:
D
Make sure that the number of cups you select
with the 2-10 cups button is consistent with
the amount of water in the water reservoir.
Please keep in mind that the coffeemaker
uses all the water in the water reservoir. If you
select a number of cups that is smaller than
the amount of water, the coffee becomes
weaker than you intended.
Press in the centre of the knob to confirm the
11
number of cups.
Press the strength select button. (Fig. 9)
12
• The coffee bean icons start to flash.
Turn the knob to select the desired coffee
13
strength (mild: 1 bean, medium: 2 beans or
strong: 3 beans) (Fig. 10).
• The display shows the selected coffee
strength.