Depaepe Telecom HD 2000 URGENCE Notice D'utilisation page 23

12) 2 sharp « beep » tones will confirm the storage of
your new setting.
13) For other settings, proceed with operations 2 up to
11.
Total Reset
General reset operation erases memories, access code
and will return all settings to factory settings (see
« SETTINGS PROGRAMMING » section page 22).
1) Make sure the telephone is connected to a powered
C.O. or PABX line.
2) Depress « RESET » key (On the small keypad
located at the back of the unit).
3) While keeping « RESET » key depressed, pick-up the
handset.
4) 2 sharp « beep » tones will be heard.
5) Release « RESET » key.
6) Enter general reset code on the keypad: « 1-5-9 ».
7) If the right code is entered, 2 sharp « beep » tones
will be heard (Don't hang up the handset).
8) Wait several seconds until 3 « beep » tones can be
heard, confirming the general reset operation.
9) Hang up the handset.
Partial reset
Partial reset operation will return almost all settings to
factory settings, but the 4 digits programming access
code as well as all numbers stored into memories will
be saved (see « LIST OF SETTINGS » section pages
24-25).
23