Depaepe Telecom HD 2000 URGENCE Notice D'utilisation page 21

Mode 2 HD2000 Urgence 2 or 3
1) Make sure HD2000 Urgence is connected to the line.
2) Lift the handset.
3) Depress "PGR" key located on the small keypad.
A "beep" sound should be heard through the receiver.
4) Dial the telephone number to store including *, # or
"Pause" if needed (22 digits maxi).
5) Press the memory location"M1, M2, M3".
A double "beep" sound confirms the right storage.
6) Replace the handset on hook.
Repeat operation 3 to 5 for the other memories.
NOTE: In case of wrong operation, a long "beep"
sound is emitted. Replace the handset on hook and start
again from the beginning.
NOTE: To erase a number stored in memory, proceed
from 1 to 3, skip section 4 (Do not enter any digit)
press the memory to erase as in 5 and terminate as in 6
and 7.
NOTE: HD2000 Urgence2 and 3 factory settings come
with "Normal" mode. In case of wrong operation, see
« LIST OF SETTINGS » pages 24-25 and check that
"Normal" mode is selected.
Setting access code :
Setting choice
04
Normal:0
21