Toshiba PMV Kit RBM-PMV0363E Manuel D'installation page 9

7
ELECTRIC WORK
4) Open the connector cover of the indoor unit after power-off and then process wiring work.
Screw
<Opening the connector cover for 4MH(2H) series>
5) Remove the connector conversion cable which is attached to the connection cable (11m) out of the box.
6) Replace the PMV connector built in the indoor unit with the connection cable of PMV Kit.
The lock mechanism is provided at side of PMV connector. Remove the connector by releasing the lock
mechanism. Fix the connection cable of PMV Kit with cord clamp for communication line.
L N U1 U2 A B
U1 U2 A B
L N
PMV connector
R(L) S(N)
(Blue, 6 cores, CN82)
> <
ABS
<Connecting control wire for 4MH(2H) series>
7) Mount the connector cover and then the work completes.
EN-15
Connector cover
L N U1 U2 A B
U1 U2 A B
L N
Cord clamp for
control wiring
R(L) S(N)
PMV connector
(Blue, 6 cores, CN82)
> <
ABS
PMV Kit
connection cable
• Work procedure 2
(In case of indoor unit which the connector conversion cable is not used, but the additional
clamp filter is used)
Applicable model: High Wall type 3H series
* For 3H-series models which have [E1] at the end of each model name, the works 1) and 2) are
unnecessary.
Procedure 1) ,2) and 3) are same to the Work procedure those in Work procedure 1.
4) After turning off the power supply, remove the terminal cover and the clamp base.
Terminal cover
Screw
<Opening the connector cover for 3H series>
5) Replace the PMV connector built in the indoor unit with the connection cable of PMV Kit.
The lock mechanism is provided at side of PMV connector. Remove the connector by releasing the lock
mechanism. Fix the connection cable of PMV Kit with cord clamp for communication line.
R(L) S(N)
Terminal block for
control/wired remote
controller wiring
U U A B
1 2
Control wire
Cord clamp
PMV connector
(Blue, 6 cores, CN82)
<Connecting control wire for 3H series>
6) Mount the clamp base and the terminal cover. The work has finished.
9
Clamp base
Screw
R(L) S(N)
U U B A
2 1
PMV kit
Connection wire
Clamp base
<Connecting power supply wire for 3H series>
EN
EN-16