Remote Controller - Mitsubishi Electric Mr.SLIM PKA-M60KA Manuel D'installation

6. Electrical work
1
C
B
A
2
D
Fig. 6-2
ON/OFF
MODE
CHECK
TEST RUN
1,4
Fig. 6-4
MODEL SELECT
ON/OFF TEMP
FAN AUTO STOP
MODE VANE AUTO START
CHECK LOUVER h
TEST RUN min
2,4 SET RESET CLOCK
Fig. 6-3
A
MODEL SELECT
TEMP
3
FAN AUTO STOP
VANE AUTO START
LOUVER h
min
2
SET RESET CLOCK
6.2. Remote controller
6.2.1. For wired remote controller
1) Two remote controllers setting
If two remote controllers are connected, set one to "Main" and the other to "Sub".
For setting procedures, refer to "Function selection of remote controller" in the
A
operation manual for the indoor unit.
6.2.2. For wireless remote controller
3
1) Installation area
• Area in which the remote controller is not exposed to direct sunshine.
• Area in which there is no nearby heating source.
• Area in which the remote controller is not exposed to cold (or hot) winds.
• Area in which the remote controller can be operated easily.
• Area in which the remote controller is beyond the reach of children.
2) Installation method (Fig. 6-2)
1 Attach the remote controller holder to the desired location using two tapping
screws.
2 Place the lower end of the controller into the holder.

Remote controller

A
Wall
B
Display panel
C
Receiver
D
• The signal can travel up to approximately 7 meters (in a straight line) within 45
degrees to both right and left of the center line of the receiver.
3) Setting (Fig. 6-3)
1 Insert batteries.
2 Press the SET button with something sharp at the end.
blinks and Model No. is lit.
MODEL SELECT
3 Press the temp button to set the Model No.
4 Press the SET button with something sharp at the end.
and Model No. are lit for three seconds, then turned off.
MODEL SELECT
Indoor
PKA (60, 71, 100)
4) Assigning a remote controller to each unit (Fig. 6-4)
Each unit can be operated only by the assigned remote controller.
Make sure each pair of an indoor unit PC board and a remote controller is
assigned to the same pair No.
5) Wireless remote controller pair number setting operation
1 Press the SET button with something sharp at the end.
Start this operation from the status of remote controller display turned off.
blinks and Model No. is lit.
MODEL SELECT
min
2 Press the button twice continuously.
Pair No. "0" blinks.
3 Press the temp button to set the pair number you want to set.
4 Press the SET button with something sharp at the end.
Set pair number is lit for three seconds then turned off.
A Pair No. of wireless remote controller
0
1
2
3–9
Outdoor A Model No.
PUZ, PUHZ 002
Indoor PC board
Factory setting
Cut J41
Cut J42
Cut J41, J42
13