Indoor Unit; Outdoor Unit; Remote Controller; Preparation Before Operation - Mitsubishi Electric MS-GE50VB Notice D'utilisation

• OPERATING INSTRUCTIONS •
N
AME OF EACH PART

Indoor unit

Air cleaning filter (Option)
Air filter
(Catechin air filter)
Air outlet
Vertical vane
Horizontal vane
Display section

Outdoor unit

Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET
1.
Remove the front lid
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries. The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
All manuals and user guides at all-guides.com
Front panel
Air inlet
Emergency
operation
switch
Page 4
Operation indicator
lamp
Remote control
receiving section
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
2.
Insert AAA
alkaline batteries
3.
Install the front lid

Remote controller

Operation display
section
MSH type
MS type
ON/OFF
(operate/stop)
button
FAN speed
control button
Page 5
MS type :
MSH type :
Operation
select
button
Page 4
ECONO
COOL
button
Page 6
VANE
control button
Page 5
LONG
button
Page 6
Use the remote controller provided with the unit only.
Do not use other remote controllers.
Setting current time
1.
Press CLOCK
3.
Press CLOCK again
• Press CLOCK gently using a thin instrument.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Temperature buttons
Page 4
Off-timer button
Page 6
On-timer button
Page 6
WIDE VANE button
Page 5
TIME set buttons
Pages 3, 6
HR. button
MIN. button
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
Remote controller
holder
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
2.
Press the TIME set buttons to
set the time
Each time / is
pressed, the set time increases
by 1 hour/minute.