Surround Sound Settings; Using The Sound Setup Menu; Channel Level Setting; Speaker Distance Setting - Pioneer HTS-LX 70 Mode D'emploi

Surround sound settings

Chapter 7
Surround sound settings
Important
• Press to set the remote control to receiver
RCV
control mode in order to operate the receiver
subwoofer (make sure that the LCD displays the
RECEIVER screen, as shown below).
RECEIVER
ADV
SURR
SURR

Using the Sound Setup menu

From the Sound Setup menu you can access all the
surround sound settings of the system.
During setup, the speakers are represented by the
following letters:
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• SR – Surround right speaker
• SL – Surround left speaker
• SW – Subwoofer

Channel level setting

The Auto MCACC feature (see page 28) should give you
the best surround sound setup. However you may find
that by further adjustment of the channel levels you can
improve the surround sound in your listening room.
This method of setting the channel levels allows you to
listen to a source and adjust the levels of each playback
channel.
A further method of setting the channel levels is to use
the test tone method. See Adjusting the channel levels
using the test tone on page 37 for more on this.
Note
1 When this function is set while MCACC Effect is on, the value for the same function adjusted with the Auto MCACC feature is overwritten.
When MCACC Effect is off, the value set here is applied, regardless of the value adjusted with the Auto MCACC feature. (The Auto MCACC
setting is not overwritten.)
2 The range of adjustment is limited when the volume level is set over 51.
F.S.
SURR
1
1 Press SETUP.
SETUP
ENTER
2 Select 'Sound Setup' then press ENTER.
ENTER
3 Select 'ChannelLevel', then press ENTER.
Use the / buttons to select a channel
4
or the / buttons to adjust the level of that
channel.
• You can adjust the level of each channel by ±10 dB.
ENTER
5 Press once when you're finished.
• If you use the Auto MCACC feature again, it will
overwrite the settings you have made here.

Speaker distance setting

The Auto MCACC feature (see page 28) should give you
the best surround sound setup. However you may find
that by further adjustment of the speaker distance
settings you can improve the surround sound in your
listening room.
Set the distance of each speaker from your normal
listening position.
ENTER
1 Open the 'Sound Setup' menu.
SETUP
ENTER
2 Select 'Distance' then press ENTER.
Use the / buttons to select a speaker
3
or the / buttons to adjust the distance.
Each speaker can be adjusted from 0.5ft to 45.0ft.
ENTER
4 Press ENTER when you're finished.
• If you use the Auto MCACC feature again, it will
overwrite the settings you have made here.
2
1
07
35
En