Recovery Tank - Duplex 280i AC Manuel D'utilisation

DUPLEX 280i
OPERATION AND USE
The tank 1 can be filled in the following ways:
E) With the tank removed from the appliance:
1) Remove the tank 1 and refill under a water tap.
2) Add a non-foaming detergent.
3) Stir the solution and re-insert the tank 1 into its housing.
B) With the tank fitted to the appliance:
1) Mix the detergent with water in a recipient.
2) Pour the liquid obtained into the tank 1.
6.1.2

Recovery tank

The dirty liquid recovery is achieved by means of the rotation of the brushes 2, which
attack the dirt, trapping it and centrifuging it toward the two conveyor belts 3. The dirt
accumulated on the active surfaces of the conveyor belts 3 is collected by the scrapers
4 and deposited into the recovery tank 5.
Before starting the appliance, you need to adjust the recovery tank height 5 to allow the
dirty liquid to be collected.
1) Turn the knob6 towards the "0" position: the recovery tank 5 lowers and allows the
scrapers 4, during the work phase, to collect the dirty liquid by adhering to the conveyor
belts 3.
2) After using the appliance, turn the knob 6 to "1" to avoid warping the scrapers 4 and
the conveyor belts 3 .
A
1
B
1
106
F.8
Rev.
1.1