Water Hardness; Loading The Rinse Aid; Important - Haier DW12-EFET Mode D'emploi

Unscrew the cap from the salt container;
There is a ring on the container with an arrow on it (see figure to the side).
If necessary, rotate the ring in an anticlockwise direction from the "
based on the hardness of the water being used.
It is recommended that adjustments be made in accordance with the following table:

Water Hardness

Clarke
º
Level
degrees
1 0 14
2
3
4
Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on
the inside panel of the door .

Loading the rinse aid

Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading the
rinse aid.
To open the dispenser, turn the " 1
tion and then pour in the rinse aid, making sure not to overfill. The
amount of rinse aid used for each cycle can be regulated by turning
the "2" dose adjustor, located beneath the
There are 6 different settings; the normal dosage setting is 3.

Important

Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage adjus-
tor should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor to a lower setting.
Selector
dH
mmol/l
position
" cap in an anti-clockwise direc-
"1" cap, with a screwdriver.
- " setting towards the "
Salt
Autonomy
c o n s u m p t i o n
(cycles/2kg)
(Grams/cycle)
en
+ " sign,
1 2
9