Rocky Mountain POWERPLAY Mode D'emploi page 16

Masquer les pouces Voir aussi pour POWERPLAY:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12
• If a battery fire occurs, do not attempt to directly extinguish it with water. You can
use water to extinguish materials surrounding the battery, but not the chemical
cells themselves. To properly extinguish a burning battery, use a Class ABC or BC
fire extinguisher. Sand can also be used to smother the fire effectively. If possible,
without exposing yourself to any personal risk of injury, bring any heated or ignited
battery or complete bike outside to prevent the fire from spreading. If the battery is
connected to a charger, the first action should be to unplug the charger or cut the
power from the grid.
Charging
• Only use the dedicated Powerplay chargers for any Powerplay battery.
• The chargers have been designed to function in 240V or 120V depending on your
location. Prior to plugging in the charger, ensure you are using the correct setting,
or damage can be inflicted on your charger. At the end of the unit, there is a switch
to select the correct input voltage.
• If the charger LED light is blinking red/green, the charger is attempting to balance
the charge between cells. Allow 4 hours for charging. If the battery is not fully
charged in 4 hours, see an authorized dealer.
• If the charger LED light is blinking green, the charger is in fault protection mode.
Unplug it from the bike and socket and start over to reset.
• Do not leave the charger in direct sunlight, especially during recharging.
• To recharge the battery:
1. Find the recharging port on the Powerplay bike and open the recharging port
protector.
2. Plug the charger into an electrical source. The green LED on the charger will
illuminate.
3. Connect the charger to the Powerplay bike and ensure that the locking system
on the port is engaged. The green LED will turn red to indicate that the battery is
recharging.
4. Once the recharge is complete, the LED will turn green. It is not mandatory to
disconnect the charger immediately after the recharge is complete, however you
should not leave the bike connected to the charger for a period longer than 12
hours.
• Recharge your Powerplay bike in an open area with clear access to an outside exit.
• Similar to all bikes and equipment with Lithium-Ion batteries, it is recommended to
only recharge the bike under supervision.
Powerplay Owner's Manual

Publicité

Table des Matières
loading

Table des Matières