Preparation; Status At Switching On - Hofmann geodyna 7200 Mode D'emploi

I
O
1
36
5-3
4-4
Operation
5.2

Preparation

• The operator should be familiar with the warnings
and cautions.
• The operator should be qualifi ed to work with the
machine.
• Alwaysensure that the wheel guard is lifted and the
gauge arm is in its home position (fully retracted).
5.2.1 Power up
• Do not keep any key pressed during power up.
Refer to (Fig. 5-3).
• Insert the power cable plug in the mains socket "1".
• Set the start switch to the "I" position.
Note: If the unit beeps and does not proceed or
if an error code is shown, refer to Chapter
F
( 7).
The unit will beep and perform a self-test now.
After switch on the fi rst screen page shown is RIM
DATA ENTRY (Fig. 4-4).
The unit is now ready for commands.

5.2.2 Status at switching on

The electronics is factory programmed so that upon
machine start-up the following operating modes are
pre-set:
– vehicle type 1 (car wheel with nominal
dimensions in inches, width 6.5" and diameter
15.0")
– entry of rim data in inches
– display of amount of unbalance in 5 g increments
– suppression of minor unbalances (limit set to:
3.5 g)
– automatic braking of wheel when guard is
opened during the measuring run
– compensation of adaptor unbalance switched
off
– Starting the measuring run by closing the wheel
guard.