Nice One OXI Série Instructions Et Avertissements Pour L'installation Et L'utilisation page 9

4 – CAUTION! – READ THIS SECTION
BEFORE MEMORISING THE
TRANSMITTER
The receiver can only memorise transmitters belonging to one
of the following 3 encoding families:
– family with "O-Code", "FloR" and "TTS" encoding;
– family with "Flo" encoding;
– family with "Smilo" encoding.
Note – Each code enables use exclusively of the standard
associated functions on the receiver.
Caution! – The encoding family of the first transmitter
memorised on the receiver also defines the relative
encoding family for the subsequent transmitters to be
memorised.
To change the encoding family set on the receiver, perform
procedure 10 – Total receiver memory deletion.
To check on the receiver whether transmitters and the associ-
ated encoding family are already memorised, proceed as fol-
lows:
01. Disconnect the receiver from the power supply.
02. Re-connect the power to the receiver and count the
number of green flashes emitted by the receiver led.
03. Check the number of flashes emitted with the data in the
table below:
– 1 flash = Flo encoding
– 2 flashes = O-Code / FloR / TTS encoding
– 3 flashes = Smilo encoding
– 5 flashes = no transmitter entered
Caution! – Before memorising a transmitter, carefully
read all memorisation procedures described below to
select the one most suited to your specific application.
5 – TRANSMITTER MEMORISATION
PROCEDURE: "Mode I" AND "Mode II"
Each control unit has a set number of commands that can be
activated according to the type of receiver: The models with
"SM" connector provide 4 or 15 commands while models
with the universal connection provide 2 outputs.
In general the commands can be associated with the trans-
mitter keys in two ways:
• "Mode I". This mode enables memorisation on the receiver
of all transmitter keys or a group of the latter at once (on trans-
mitters with more than one identity code such as model ON9).
The keys are automatically associated with the pre-set com-
mands of the control unit or the receiver outputs, on models
with universal connectotion.
• "Mode II". This mode enables memorisation on the receiv-
er of a single transmitter key. The user has a free choice of
which command, among those available on the control unit
(maximum 4) or which output of the receiver to be associated
with the selected key.
– "Extended Mode II" (only for models with "SM" connector).
This mode can only be used with control units using the con-
nection system "T4 Bus". The "Extended Mode II" is the same
as "Mode II" with the additional option to choose the required
command from those available in the "Table of commands"
(maximum 15), as provided in the manual of the control unit
connected to the receiver.
EN
9