Nice One OXI Série Instructions Et Avertissements Pour L'installation Et L'utilisation page 13

Note 1:
If the transmitter is memorised in "Mode I" any key can be
pressed.
If the transmitter is memorised in "Mode II" the entire proce-
dure must be repeated for each memorised key to be deleted.
Alternatively this function can be performed using the O-Box
or O-View programming unit.
10 – ENABLING (or disabling)
THE RECEIVER FOR TRANSMITTER
MEMORISATION
This function enables the user to prevent memorisation of new
transmitters when the procedures "in the vicinity" (factory
setting is ON) or with "enable code" (factory setting is ON)
are used as described in this manual. To enable or disable this
function, proceed as follows:
01. Disconnect the receiver from the power supply and wait 5
seconds.
02. Reconnect the power and switch on by pressing the
receiver key until the relative led has completed the sig-
nals indicating the type of code stored in the memory
(see paragraph 5) and the procedure is activated, indicat-
ed by 2 short orange flashes. Then release the key.
03. (within 5 seconds) Press the receiver key repeatedly to
select one of the following functions (Warning! – on each
press of the key the Led changes colour to indicate the
currently selected function):
• Led OFF = No lock enabled
• Led RED = Memorisation "in the vicinity" locked
• Led GREEN = Memorisation with "enable code" locked
• Led ORANGE = Both memorisation modes locked ("in
the vicinity" and with "enable code").
04. (within 5 seconds) Press any key of a transmitter already
memorised on the receiver to save the selected function.
Alternatively the lock (or unlock) function can be applied using
the O-Box or O-View programming unit.
EN
13