Nice One OXI Série Instructions Et Avertissements Pour L'installation Et L'utilisation page 12

03. On the NEW transmitter, press the same key pressed in
EN
point 01 for at least 3 seconds and then release.
04. On the OLD transmitter, press the same key pressed in
point 02 for at least 3 seconds and then release.
Note 1:
If the OLD transmitter is memorised in "Mode I" the NEW
transmitter will also be memorised in "Mode I". In this case,
during the procedure press any key on either the OLD or NEW
transmitter.
If the OLD transmitter is memorised in "Mode II" the NEW
transmitter will also be memorised in "Mode II". In this case,
during the procedure press the required command key on the
OLD transmitter and the associated key to be memorised for
this command on the NEW transmitter. This procedure must
also be repeated for each key of the NEW transmitter to be
memorised.
• Preventing accidental use of this memorisation procedure
To prevent the continuous reception of a signal transmitted at
random by a transmitter not part of the system from acciden-
tally activating the memorisation procedure, this procedure
can be "locked" (or unlocked) by programming the function in
paragraph 10.
12
8 – TOTAL RECEIVER MEMORY DELETION
All transmitters memorised can be deleted from the receiver
memory, or all data present in the latter can be deleted as
follows:
01. Press and hold the receiver key and check the following
changes in Led status:
– (after approx. 4 seconds) the green led illuminates;
– (after approx. 4 seconds) the green led turns off;
– (after approx. 4 seconds) the green led starts flashing.
02. At this point release the key exactly......
• on the 3rd flash, to delete all transmitters, or,
• on the 5th flash, to delete the entire memory of the
receiver, including configurations and encoding families of
the transmitters.
Alternatively this function can be performed using the O-Box
or O-View programming unit.
9 – DELETING A SINGLE TRANSMITTER
FROM THE RECEIVER MEMORY
A single transmitter (in your possession) memorised can be
deleted from the receiver memory as follows:
01. Press and hold the receiver key.
02. After approx. 4 seconds the green led illuminates (keep
the key pressed).
03. On the transmitter to be deleted from the memory, press
and hold any key (see note 1) until the led on the receiver
emits 5 green flashes (= deletion confirmed).