Nice One OXI Série Instructions Et Avertissements Pour L'installation Et L'utilisation page 16

15 – ENABLING (or disabling)
EN
THE "REPEATER" FUNCTION
(Function available only on models OXIT, OXITFM, OX2T,
OX2TFM, in combination with transmitters using O-Code
encoding).
[with O-Box] – If an automation is to be controlled at a dis-
tance greater than that normally covered by the transmitter
and receiver, a second receiver may be used (up to a maxi-
mum of five) serving to re-transmit, via radio, the command to
the final receiver (in which the sending transmitter identity
code is memorised), so that this can execute the command.
To enable or disable this function (factory setting OFF) pro-
gramming must be performed both on the additional receivers
and transmitters.
16 – MANAGING RELEASE OF THE
TRANSMITTER KEYS
(Function available only on transmitters using O-Code
encoding)
[with O-Box / O-View] – Normally, after sending a com-
mand, on release of the key the manoeuvre is not stopped
immediately but proceeds for a very short pre-set interval.
If necessary, the manoeuvre can be interrupted at the exact
time of key release (required for example during minimal
adjustments) by enabling this function (factory setting OFF).
16
17 – ENABLING (or disabling)
COMMAND DELIVERY ON THE
"T4 BUS" NETWORK
[with O- View] – On systems in which connection is via the
"T4 Bus", if more than one receiver is installed, and there is the
need for control at a distance greater than that normally cov-
ered by the transmitter and receiver, this function can be
enabled (on at least 2 receivers) to increase the receiver
reception range.
This enables the receiver that receives a command "via radio"
to re-transmit the command via the Bus cable to the final
receiver (in which the sending transmitter identity code is
memorised), so that this can execute the command.
To enable or disable the option to receiver and/or send radio
codes on the "T4 Bus" in a receiver (factory setting OFF), the
receivers concerned must be duly programmed, using the O-
View programming unit.
18 – CREATING THE "FAMILY GROUPS"
OF TRANSMITTERS
[with O-Box] – Each code memorised on the receiver can
be associated with one or more "family groups", from the 4
available.
The formation of groups and their activation or deactivation (fac-
tory setting OFF) is managed by means of the O-Box program-
ming unit while use of the groups, for example in a set time-
band, is managed by means of the O-View programming unit.