2 6 Menu Item Set Push-Button; Extending The Functions Of The Buttons Chime; 2 7 Menu Item Exit; Exiting The Programming Mode - Monacor PA-1200C Notice De Montage Et D'utilisation

5.2.6 Menu item
SET PUSH-BUTTON
Extending the functions
of the buttons CHIME
With the buttons CHIME A (2), CHIME B (3) and
CHIME C (4), it is not only possible to trigger a
chime, but also to, at the same time or subsequently,
energize a relay and / or start an announcement from
the digital message insertion PA-1120DM .
1) Go to the menu item
the button UP or DOWN and call up the submenu
for the button selection with the button ENTER .
2) The display shows:
SET PUSH-BUTTON
ƊCHIME A
With the button UP or DOWN, select the button
to which additional functions are to be assigned
and then confirm with the button ENTER .
3) The display changes to:
SET REL |123
Ɗ1 |
4) The settings for the relay / s or the selection of
an announcement is made in the same way as
described in chapter 5 .2 .2 D to G .
5) After the setting for a button CHIME has been
concluded with the button ENTER, the display
shows the menu again:
MENU
SET PUSH-BUTTON
6) Repeat the procedure for the next button CHIME
or, to exit the programming menu, select the
menu item
ƊEXIT
confirm with the button ENTER . The display
shows the date and the time again .
ƊSET PUSH-BUTTON
with the button DOWN and
5.2.7 Menu item

Exiting the programming mode

Go to the menu item
DOWN . Press the button ENTER to exit the pro-
gramming mode . The display switches to the time
and the date .

5.3 Display

In the standard mode, the first line of the display (1)
with
indicates the time (a) and the timer status (b) ON
or OFF . In the second line, the date (d) with the
weekday (e) is shown . The weekday is indicated by
a number: = Monday,
1
When the timer carries out a program step that
triggers a chime, the chime (CHIME A, B, or C) will
be displayed instead of the time . When a relay is
energized, the holding time (c) will be shown in
count-down mode .

6 Specifications

Audio output: . . . . 0 dBu, unbal .
Control outputs: . . 3 floating switching
Storage locations: . 40
Quartz precision: . . ±20 ppm
Power supply: . . . . ⎓ 17 V via PA amplifier or
Dimensions: . . . . . 195 × 40 × 90 mm (W × H × D)
Weight: . . . . . . . . 220 g
Subject to technical modification .
All rights reserved by MONACOR
GmbH & Co. KG. No part of this instruction manual
may be reproduced in any form or by any means for any
commercial use.
EXIT
with the button
ƊEXIT
= Sunday .
7
contacts (NO / NC),
max . switching load
⎓ 24 V/ 500 mA
via the basic unit
INTERNATIONAL
®
17