2 4 Menu Item Delete Settings; Deleting The Switching Times; Set Date & Time; Setting Date And Time - Monacor PA-1200C Notice De Montage Et D'utilisation

4) To exit the menu without selection of a storage
location, select the menu item
button UP and confirm with the button ENTER .
5) Unlike the menu
menu allows you to directly select the settings to
be changed . Select the setting with the button
UP or DOWN and confirm with ENTER . To change
settings, proceed in the same way as you store
new switching times, see chapter 5 .2 .2 menu
item
NEW SETTINGS
6) When all changes have been made, press the
button DOWN repeatedly until
is displayed . The current settings are successively
displayed once again . Then the settings can be
stored or rejected .
7) When the settings have been stored, the storage
location is displayed . To confirm, press the but-
ton ENTER again . Then the menu item
is selected again .
SETTINGS
8) Either change further storage locations or, to
exit the programming mode, go to the menu
item
ƊEXIT
the button ENTER .
5.2.4 Menu item

Deleting the switching times

1) Go to the menu item
with the button UP or DOWN and call up the
submenu with the button ENTER to select the
storage location .
2) The display shows:
SELECT MEMORY
ƊMEM01 [xx:xx]
The first storage location with the corresponding
starting time is selected . To delete this storage
location, press the button ENTER . Otherwise,
select the storage location with the button UP or
DOWN and then press the button ENTER .
3) After pressing the button ENTER, the display
switches to
DELETE MEMxx ?
ƊYES [xx:xx]
To delete the storage location, press the button
ENTER .
16
a
1
c
d
ƊEXIT
NEW SETTINGS
.
ƊSAVE & EXIT
with the button DOWN and press
DELETE SETTINGS
ƊDELETE SETTINGS
b
2
CHIME A CHIME B
UP
e
4) To cancel the procedure, switch to
with the the button DOWN and confirm with the button
ENTER . The storage location is not deleted .
5) It is also possible to exit the menu without
, the editing
selecting a storage location . For this purpose,
press the button UP repeatedly until
displayed . Then exit the menu with the button
ENTER .
5.2.5 Menu item
The date and the time are automatically set by the
radio clock receiver . However, if this is not the case
due to inference with reception, the date and time
can also be set manually . When the reception is clear
again, the radio module will automatically update
the date and the time . The clock is battery-buffered
and continues working even when the power supply
is interrupted .
ƊEDIT
1) Go to the menu item
with the button UP or DOWN and call up the
submenu for changing the calendar day with
the button ENTER:
SET DATE
2) Set the current day with the button UP or DOWN
and confirm with the button ENTER .
3) Repeat the procedure for the month and the year .
Then the current setting is displayed . Confirm it
with the button ENTER .
4) After confirming the date, the menu for chang-
ing the time is displayed, e . g .:
SET TIME
09:15
Proceed in the same way to update the hours and
the minutes and confirm with the button ENTER .
5) To exit the programming mode after changing
the time, select the menu item
button DOWN and press the button ENTER .
PA-1200 C CLOCK MODULE
3 4 5
CHIME C
0
DOWN ENTER PROG.
LEVEL
SET DATE & TIME

Setting date and time

ƊSET DATE & TIME
[DAY]
16/05/17
[HOUR]
6
10
➃
with
ƊNO
is
ƊEXIT
with the
ƊEXIT