Sharp LL-T18A1 Mode D'emploi page 17

Adjusting the screen display
MODE SELECT Menu
M O D E S E L E C T
[ O D S H - P O S I T I O
O SD V - P O S I T I O
SCAL I NG
I N P U T
4 0 0 L I E N S
L ANGU AGE
4
1 2 8 0 x 1 0 2
V : 7 5 H z
Notes:
- Depending on the resolution of the input signal,
even if menu options can be selected, the display
may not change.
- To choose a menu option:
- To complete adjustment: MENU button
OSD H-POSITION (OSD horizontal position)
The position of the OSD Menu can be moved to the
left and right. ( buttons)
OSD V-POSITION (OSD vertical position)
The position of the OSD Menu can be moved up
and down. ( buttons)
SCALING (Level of scaling)
Adjusts the image to optimum sharpness when
Screen expansion is taken. (
Notes:
- When the display mode is set to less than
1280 x 1024 pixels, the display is enlarged to
cover the whole screen (i.e. the side ratio of the
display may change).
- Display modes of 1280 x 1024 pixels cannot be
changed.
INPUT (Input mode)
The input mode can be set. (
VESA: VESA mode
MAC: Power Macintosh mode
400 LINES (degree of resolution)
You can specify the horizontal resolution of a 400-
line screen when using US text, etc. (
640: 640 X 400 dot mode
720: 720 X 400 dot mode (US text etc.)
Note:
- As the resolution input for other than 400 lines is
done automatically, there is no need to set it.
< A N A L OG >
N ]
N
L VEL 2
L V E EL 1 E
V E S A M A C
6 4 0 7 2 0
H : 8 0 k H z
button
buttons)
buttons)
buttons)
(When using an analog signal)
LANGUAGE
You can choose the language used in OSD Menu.
1. Press the button.
Language Selection Menu (LANGUAGE) will
appear.
2.Chose the desired language by
3. Press MENU button or the
Language Selection Menu will disappear.
17
button.
button, and